User manual
Network Settings
myUTN User Manual 44
3.6
How to Configure POP3 and SMTP (only
myUTN-80 and later)
You must configure the protocols POP3 and SMTP on the UTN server
so that the notification service (Ö57) and the remote
maintenance via email (
Ö31) will work properly.
POP3
'POP3' (Post Office Protocol Version 3) is a transfer protocol that a
client can use to fetch emails from a mail server. POP3 is required to
administer the UTN server via email.
SMTP
'SMTP' (Simple Mail Transfer Protocol) is a protocol that controls the
sending of emails in networks. SMTP is required to administer the
UTN server via email and to run the notification service.
What Do You Want
to Do?
’Configuring POP3’ Ö44
’Configuring SMTP’ Ö45
Configuring POP3
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK - Email.
3. Configure the POP3 parameters; see: Table 7 Ö44.
4. Click Save & Restart to confirm.
ª The settings are saved.
Table 7: POP3 Parameters
Parameters Description
POP3 Enables/disables the POP3 functionality.
POP3 - Server name Defines a POP3 server via the IP address or the host
name.
The host name can only be used if a DNS server was
configured beforehand.