User manual
Network Settings
myUTN User Manual 45
Configuring SMTP
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK - Email.
3. Configure the SMTP parameters; see: Table 8 Ö45.
4. Click Save & Restart to confirm.
ª The settings are saved.
Table 8: SMTP Parameters
POP3 - Server port Defines the port used by the UTN server for receiving
emails. The port number 110 is preset. When using
SSL/TLS, enter 995 as port number.
POP3 - Security Defines the authentication method to be used (APOP /
SSL/TLS). When using SSL/TLS, the cipher strength is
defined via the encryption level
Ö80.
POP3 - Check mail every Defines the time interval (in minutes) for retrieving emails
from the POP3 server.
POP3 - Ignore mail
exceeding
Defines the maximum email size (in Kbyte) to be
accepted by the UTN server.
(0 = unlimited)
POP3 - User name Defines the user name used by the UTN server to log on
to the POP3 server.
POP3 - Password Defines the password used by the UTN server to log on
to the POP3 server.
Parameters Description
SMTP - Server name Defines an SMTP server via the IP address or the host
name.
The host name can only be used if a DNS server was
configured beforehand.
SMTP - Server port Defines the port number used by the UTN server to send
emails to the SMTP server. The port number 25 is
preset.
Parameters Description