User manual

Network Settings
myUTN User Manual 49
Using the UTN Server (myUTN-54) in a Wireless Network
To operate the UTN server in a wireless network, the WLAN and
security settings of the UTN server must match those of the wireless
network.
In order to configure the UTN server you must first establish a
connection to a wired network by means of the network connector
RJ-45; see: 'Quick Installation Guide'.
Requirements
; The UTN server is connected to the network and the mains
voltage.
; The UTN server is known to the wired network via its IP address,
see: Ö13.
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK - WLAN.
The available WLANs are shown in the network list. Decide in
which WLAN you want to operate the UTN server.
3. Configure the WLAN parameters in such a way that they match
the parameters of the WLAN to be used; see: Table 9 Ö50.
4. Tick WLAN to enable the WLAN module in the UTN server.
5. Click Save & Restart to confirm.
The settings are saved.
6. Remove the network cable (RJ-45) from the UTN server.
The connection to the wired network will be deactivated.
ª The UTN server automatically switches to the WLAN mode.
The connection to the WLAN will be established.
If the UTN server gets a new IP address in the course of the network
change, the connection to the myUTN Control Center will be
interrupted.