User manual

Device Settings
myUTN User Manual 54
3. Tick Date/Time.
4. Enter the IP address or the host name of the time server into
the Time server box.
(The host name can only be used if a DNS server was configured beforehand.)
5. Select the code for your local time zone from the Time zone list.
6. Click Save & Restart to confirm.
ª The settings are saved.
4.3 How to Configure the UTN (SSL) Port
A common port will be used for the data transfer between the UTN
server and the client. Depending on the type of connection, two
port variants are available.
UTN Port
Unencrypted connection means that client and UTN server
communicate via the UTN port. The port number 9200 is preset.
UTN SSL Port
Encrypted connection means that client and UTN server
communicate via the UTN SSL port. The port number 9443 is preset.
In order to use an encrypted connection you must enable the port
encryption; see: Ö103.
This UTN port or the UTN SSL port must not be blocked by a firewall.
If required, you can change the port number on the UTN server.
Requirements
; In order that the SEH UTN Managers installed on the client
receive the current port number, the 'SNMPv1' parameter must
be activated; see Ö41.
Proceed as follows:
1. Start the myUTN Control Center.
2. Select DEVICE – UTN port.
3. Enter the port number into the UTN port or UTN SSL port box.
4. Click Save & Restart to confirm.
ª The settings are saved.