User manual

Working with the SEH UTN Manager
myUTN User Manual 64
5.3 How to Connect a USB Device to a Client
A USB device that is connected to the UTN server can be connected
to the client. The USB device can then be used by the client as if the
USB device was directly connected to the client.
Requirements
; The SEH UTN Manager (complete version) is installed on the
client; see: Ö20.
; The USB device is shown in the selection list; see: Ö63.
; All provisions (driver installation, etc.) necessary to operate the
USB device locally (i.e. connected directly to the client) should
have been met on the client. Ideally, the USB device has been
connected and operated on the client locally according to the
instructions of the manufacturer.
; The USB device is not connected to another client.
Proceed as follows:
1. Start the SEH UTN Manager.
2. Mark the relevant USB device in the selection list.
3. Select Device – Activate from the menu bar.
ª The connection will be established.
Fig. 11: SEH UTN Manager - Activating the Device