User manual
Security
myUTN User Manual 86
6.4 How to Control Access to USB Devices (only
myUTN-80 and later)
Via the USB ports you can control the access to the USB devices that
are connected to the UTN server. Two security methods are available
for each USB port. Both security methods can also be used in
combination.
USB Port Key Control
In the course of the key control a key is specified for the USB port
via the myUTN Control Center. By entering the key, the USB device
that is connected to the USB port is protected against unwanted
access.
The USB device will no longer be shown in the SEH UTN Manager.
This means that a user will not be able to make changes to the USB
device or to establish a connection between the client and the USB
device.
To make the USB device available, the user must enter the key for
the USB port on the client. This is done via the SEH UTN Manager. By
changing the key in the myUTN Control Center the user can (once
again) lose its permission to access the USB device.
USB Port Device
Assignment
Device assignment means that a USB device is permanently assigned
to each USB port via the myUTN Control Center. A USB device can
then only be operated together with its assigned USB port.
The device assignment makes sure that the (security) settings of the
USB port and the USB device are not bypassed. If a device other
than the assigned USB device is connected to the USB port, it
cannot be operated.
What Do You Want
to Do?
’Blocking access to USB devices’ Ö87
’Unblocking access to USB devices’ Ö87
’Specifying the Device Assignment on the USB Port’ Ö88
’Disabling the USB Port Access Control’ Ö88