User manual

Maintenance
myUTN User Manual Mac 110
Resetting the Parameters via the InterCon-NetTool
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the UTN server from the device list.
3. Select Actions – Default Settings from the menu bar.
4. Click Finish.
 The parameters are reset.
Resetting the Parameters via the Reset Button
LEDs, the reset button and various ports can be found on the UTN
server. These components are described in the 'Quick Installation
Guide'.
Using the reset button you can reset the UTN server’s parameter val-
ues to their default setting. There are two procedures:
1. myUTN-50a to myUTN-250
2. myUTN-800
The two procedures are each described in the following. The illustra-
tions may differ slightly from your UTN server model.
myUTN-50a to
myUTN-250
The reset process can be divided into two phases:
• During phase 1, the device is forced into the reset mode. During
the reset mode, the parameters are reset.
• The second describes the restart of the device.
IMPORTANT: The reset mode is indicated by the synchronous
blinking of the activity LED (yellow) and the status LED (green)
and last for about five intervals.
You must release the reset button within this time frame, other-
wise the device switches to the BIOS mode. If this happens, try
the reset again.
The phases are described in the following: