Manualshelf

User manual

ManualsBrandsSEH ManualsNetworkingmyUTN-54
141142143144145146147148149150
Appendix - Troubleshooting
myUTN User Manual Mac 143
Abb. 19: InterCon-NetTool - UTN Server in BIOS Mode
The software must be loaded on the UTN server so that the UTN
server can switch from the BIOS mode to the normal mode.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the UTN server from the device list.
(You will find the UTN server under the filter 'BIOS Mode'.)
3. Select Installation – IP Wizard.
The IP Wizard is started.
4. Follow the instructions of the wizard in order to assign an IP
address to the UTN server.
The IP address is saved.
5. Carry out a software update on the UTN server; see:
115
.
The software will be saved in the UTN server. The UTN server
switches to the normal mode.