User manual

Administration Methods
myUTN User Manual Mac 19
2.1 Administration via myUTN Control Center
Which Functions Are
Supported?
The myUTN Control Center includes all features for the administra-
tion and monitoring of the UTN server.
The myUTN Control Center is stored in the UTN server and can be
displayed by means of a browser software (e.g. Safari).
Requirements
 The UTN server is connected to the network and the mains
voltage.
 The UTN server has a valid IP address.
Starting the myUTN
Control Center
Proceed as follows:
1. Open your browser.
2. Enter the IP address of the UTN server as the URL.
 The myUTN Control Center appears.
If the myUTN Control Center is not displayed, check the proxy set-
tings of your browser.
You can also start the myUTN Control Center via the software tools
'SEH UTN Manager' and 'InterCon-NetTool'
• To start the myUTN Control Center via the InterCon-NetTool,
mark the UTN server in the device list and select Actions –
Launch Browser from the menu bar.
• To start the myUTN Control Center via the SEH UTN Manager,
mark the UTN server in the selection list and select UTN Server –
Configure from the menu bar.