Manualshelf

User manual

ManualsBrandsSEH ManualsNetworkingmyUTN-54
31323334353637383940
Network Settings
myUTN User Manual Mac 34
Configuring IPv4 Parameters via the myUTN Control Center
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK – IPv4.
3. Configure the IPv4 parameters; siehe: Tabelle 2
34
.
4. Click Save & Restart to confirm.
The settings are saved.
Tabelle 2: IPv4 Parameters
Configuring IPv4 Parameters via the SEH UTN Manager
Requirements
The SEH UTN Manager (complete version) is installed on the
client; see: 21.
The UTN server is shown in the selection list; see: 64.
Proceed as follows:
1. Start the SEH UTN Manager.
2. Select the UTN server from the selection list.
3. Select UTN Server – Set IP Address from the menu bar. The Set
IP Address dialog appears.
4. Enter the relevant TCP/IP parameters.
5. Click OK.
The settings are saved.
Parameters Description
DHCP
BOOTP
ARP/PING
Enables or disables the protocols DHCP, BOOTP, and
ARP/PING.
Protocols offer various possibilities to save the IP address
in the UTN server.
(See
’Saving the IP Address in the UTN Server’
14
.)
We recommend disabling these options once an IP
address has been assigned to the UTN server.
IP Address IP address of the UTN server
Subnet mask Subnet mask of the UTN server
Gateway Gateway address of the UTN server