User manual

Network Settings
myUTN User Manual Mac 35
Configuring IPv4 Parameters via InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 27.
 The network scan via Multicast has been enabled in the
InterCon-NetTool.
 The router in the network forwards multicast requests.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the UTN server from the device list.
The UTN server is displayed in the device list under the filter 'ZeroConf' with an IP
address from the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard.
The IP Wizard is started.
4. Follow the instructions of the Wizard.
 The settings are saved.
Abb. 7: InterCon-NetTool - IP Wizard