User manual

Network Settings
myUTN User Manual Mac 42
SMTP
'SMTP' (Simple Mail Transfer Protocol) is a protocol that controls the
sending of emails in networks. SMTP is required in the UTN server to
administer the UTN server via email and to run the notification ser-
vice.
What Do You Want
To Do?
 ’Configuring POP3’ 42
 ’Configuring SMTP’ 43
Configuring POP3
Requirements
 The UTN server is set up as user with its own email address on a
POP3 server.
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK – Email.
3. Configure the POP3 parameters; siehe: Tabelle 7 42 .
4. Click Save & Restart to confirm.
 The settings are saved.
Tabelle 7: POP3 Parameters
Parameters Description
POP3 Enables/disables the POP3 functionality.
POP3 - Server name Defines the POP3 server via the IP address or the host
name.
The host name can only be used if a DNS server was
configured beforehand.
POP3 - Server port Defines the port used by the UTN server for receiving
emails. The port number 110 is preset. When using
SSL/TLS, enter 995 as port number.
POP3 - Security Defines the authentication method to be used
(APOP/SSL/TLS). When using SSL/TLS, the cipher
strength is defined via the encryption level 80.
POP3 - Check mail every Defines the time interval (in minutes) for retrieving emails
from the POP3 server.