User manual

Network Settings

myUTN User Manual Mac 43

Configuring SMTP

Requirements

 The UTN server is set up as user with its own email address on a

SMTP server.

Proceed as follows:

1. Start the myUTN Control Center.

2. Select NETWORK – Email.

3. Configure the SMTP parameters; siehe: Tabelle 8

43

4. Click Save & Restart to confirm.

 The settings are saved.

Tabelle 8: SMTP Parameters

POP3 - Ignore mail

exceeding

Defines the maximum email size (in Kbyte) to be

accepted by the UTN server.

(0 = unlimited)

POP3 - User name Defines the user name used by the UTN server to log on

to the POP3 server.

POP3 - Password Defines the password used by the UTN server to log on

to the POP3 server.

Parameters Description

SMTP - Server name Defines the SMTP server via the IP address or the host

name.

The host name can only be used if a DNS server was

configured beforehand.

SMTP - Server port Defines the port number used by the UTN server to send

emails to the SMTP server. The port number 25 is

preset.

SMTP - TLS Enables/disables TLS.

The security protocol TLS (Transport Layer Security)

serves to encrypt the transmission between the UTN

server and the SMTP server. The cipher strength is

defined via the encryption level

80