User manual

Network Settings
myUTN User Manual Mac 47
In order to configure the UTN server you must first establish a con-
nection to a wired network by means of the network connector
RJ-45; see: 'Quick Installation Guide'.
Requirements
 The UTN server is connected to the network and the mains
voltage.
 The UTN server is known to the wired network via its IP address,
see: 14.
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK – WLAN.
The available WLANs are shown in the network list. Decide in
which WLAN you want to operate the UTN server.
3. Configure the WLAN parameters in such a way that they match
the parameters of the WLAN to be used; siehe: Tabelle 9 48 .
4. Tick WLAN to enable the WLAN module in the UTN server.
5. Click Save & Restart to confirm.
The settings are saved.
6. Remove the network cable (RJ-45) from the UTN server.
The connection to the wired network will be deactivated.
 The UTN server automatically switches to the WLAN mode.
The connection to the WLAN will be established.
If the UTN server gets a new IP address in the course of the network
change, the connection to the myUTN Control Center will be inter-
rupted.