User manual

Device Settings
myUTN User Manual Mac 57
• only one power supply works
• SD card errors (read and write errors, no SD card)
Errors are displayed in codes. The meaning of the codes you will find
in chapter ’Informationen im Anzeigefeld (nur myUTN-800)’ 143
Proceed as follows:
1. Start the myUTN Control Center.
2. Select Device – Notification.
3. In the Display panel area, tick the options with the desired
message types.
 The settings are saved.
If there is no error state, i.e. the UTN server is operational, the iden-
tifier is displayed 51.
The optional acoustic signals ideally complement the error messages
in the display panel. For further information; see: 59.
4.9 How to Configure Acoustic Signals (myUTN-800
only)
The myUTN-800 Dongleserver gives acoustic feedback when:
• a USB dongle is connected to the UTN server
• the UTN server restarts
• the parameters are reset
These acoustic signals cannot be turned off.
Optionally further acoustic signals can be configured for when
• only one power supply works
• an SD card error exists (read and write errors, no SD card)