User manual

Device Settings
myUTN User Manual Mac 60
Entering IPv4 Management VLANs
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK – IPv4 VLAN.
3. Configure the IPv4 management VLAN parameters; siehe:
Tabelle 11 61 .
4. Click Save to confirm.
 The settings are saved.
Tabelle 10: IPv4 management VLAN parameters
Entering IPv4 client VLANs
Proceed as follows:
1. Start the myUTN Control Center.
2. Select NETWORK – IPv4 VLAN.
Parameters Description
IPv4 management VLAN Enables/disables the forwarding of IPv4 management
VLAN data.
VLAN ID ID for the identification of the IPv4 management VLAN.
(0–4096).
IP Address IP address of the UTN server 34.
Subnet mask Subnet mask of the UTN server 34.
Access from any VLAN Enables/disables the administrative access (web,
SNMP) to the UTN server via IPv4 client VLANs.
If this option is enabled, the UTN server can be
administrated via all VLANs.
The change in the SNMP access only becomes effective after
a restart of the UTN server.
Access via LAN (untagged) Enables/disables the administrative access to the UTN
server via IPv4 packets without tag.
If this option is disabled, the UTN server can only be
administrated via VLANs.