Product manual

4-2
Operating the Drive
650 Series AC Drive
REMOTE
LOCAL
Local Control Operation
Connect the keypad to the drive and power -up
the unit.
The drive will display the Local screen. If not,
refer to Chapter 5 and select Local Control.
Follow the instructions opposite to start and
stop the motor.
Remote Control Operation
Connect the keypad to the drive and power-up the unit.
The drive will display the Local screen. Refer to Chapter 5 and select Remote Control.
Check that the speed potentiometer is set to zero.
Follow the instructions below to start and stop the motor using your control panel.
Reverse the motor’s direction of rotation using the DIN2 connection (0V = forward, +24V =
reverse). Alternatively, swap two of the motor phases
(WARNING: Disconnect the mains
supply first)
.
The installation of your drive is now complete:
The drive will operate as an open-loop drive. It is programmed to control an induction motor of
equivalent power, current, and voltage rating to the drive. The drive's default parameters will
operate effectively under most circumstances, however you may wish to refer to Chapter 6 to
tune the drive to your system.
Reverse
LOCAL
Press to start the motor
and it will ramp to the setpoint
Press to stop the motor
and it will ramp to zero
Press to apply a small setpoint
(see Reverse below)
From zero, release
and press again for
a negative setpoint
STOP START
Close the RUN switch (DIN1)
RUN SWITCH
0
100
5
POTENTIOMETER
STOP START
RUN SWITCH
Open the RUN switch (DIN1)
and the motor will ramp to zero
Apply a small speed setpoint
and the motor will ramp to
the setpoint
Press the Start button
0
100
5
POTENTIOMETER
Apply a small speed setpoint
and the motor will ramp to
STOP
PUSHBUTTONS
START
STOP
PUSHBUTTONS
START
(DIN1)
the setpoint
Press the Stop button
(DIN4/DOUT2)
and the motor will ramp
to zero
Single Wire Starting Push-button Starting
(Applications 1 & 5 only)