Product manual
12-1
Applications
650 Series AC Drive
12
A
PPLICATIONS
The Default Application
The drive is supplied with 6 Applications, Application 0 to Application 5. Each Application
recalls a pre-programmed structure of internal links when it is loaded.
•
Application 0 will not control a motor. Loading Application 0 removes all internal links.
•
Application 1 is the factory default application, providing for basic speed control
•
Application 2 supplies speed control using a manual or auto setpoint
•
Application 3 supplies speed control using preset speeds
•
Application 4 is a set-up providing speed control with Raise/Lower Trim
•
Application 5 supplies speed control with Run Forward/Run Reverse
IMPORTANT:
Parameter values are not changed by loading a new Application. Refer to Chapter 4: The
Keypad – Special Menu Features to reset the drive to factory default values which are
suitable for most applications.
How to Load an Application
In the menu, go to and press the key.
The Applications are stored in this menu.
Use the
keys to select the appropriate Application by number.
Press the
key to load the Application.
Application Description
Control Wiring for Applications
10k Speed
Setpoint
*
**
*
Terminal
10
9
8
7
6
5
4
3
2
1
Control
RL1A
RL1B
User Relay
V
A
default source = A
DIN4/DOUT2
DIN3
DIN1
+24V
AOUT1
+10V REF
AIN2
AIN1
0V
DIN2
Not Stop
Jog
Run
+24V
AOUT1
+10V REF
Feedback
Setpoint
0V
Direction
Reset
Lower
Run
+24V
AOUT1
+10V REF
not used
not used
0V
Raise
Preset 0
Preset Select
Preset Select
Run
AOUT1
+10V REF
Preset Select
+24V
Preset 0
0V
Manual Setpoint
Direction
Select
Manual Run
+24V
AOUT1
+10V REF
Auto Setpoint
0V
Auto Run
Manual/Auto
Presets Raise/Lower PID
HealthHealthHealth
Health
Not Stop
Jog
Run
+24V
AOUT1
+10V REF
Feedback
Setpoint
0V
Direction
Basic Speed
Control
(default)
Health
RL1A
RL1B
APPLICATION 1
APPLICATION 2
APPLICATION 3 APPLICATION 4 APPLICATION 5
normally open contact (relay)
2-position switch
normally open push-button
normally closed push-button
Key to Application Diagrams
DEFAULT