Specifications

Room Requirements

Electrical Requirements

• All units are shipped from the factory for use with 120 VAC. In the event that

operations at 240 VAC is required, please notify the factory.

• Each unit requires a separate NEMA 5-15R receptacle protected by a 15 Amp circuit

breaker.

• A standard 7 foot 6 inch power cord with a molded NEMA 5-15 plug is supplied

with each unit.

Mounting Instructions

• The SEI DC-UPS weighs between 32 and 36 lbs, depending upon the model.

• The SEI DC-UPS is designed to mount to a rack or wall without further

requirements for additional mounting kits. For wall mounting, a user supplied 3/4-

inch plywood backboard or equivalent is required. The DC-UPS should be fastened

to the backboard using number ten wood screws. A number 27drill can be used to

provide a pilot hole for the screws. All of the screws should be tightened with a

torque of 30 in/lb minimum and 34 in/lb maximum.

• The unit should be mounted vertically in a clean dry area where the ambient

temperature does not exceed 40°C (104° F)

• It is important that ventilation for the unit be provided. Leave adequate space above

and below the unit so that unrestricted airflow is allowed to the unit. It is suggested

that 5 inches of space be allocated around the top of the unit.

• The DC-UPS is supplied with mounting angles suitable for 19" standard, racks or

wall mounting.

• The mounting slots on each rack adapter are spaced in conformance with EIA

standard RS-310-B.