Installation Instructions

Hardware
Video
Power
Chipset Amlogic S905Y2
Video
Decoding
VP9 Profile-2 up to 4Kx2K@60fps
H.265 HEVC MP-10@L5.1 up to 4Kx2K@60fps
AVS2-P2 Profile up to 4Kx2K@60fps
H.264 AVC HP@L5.1 up to 4Kx2K@30fps
H.264 MVC up to 1080P@60fps
MPEG-4 ASP@L5 up to 1080P@60fps (ISO-14496)
WMV/VC-1 SP/MP/AP up to 1080P@60fps
AVS-P16(AVS+) /AVS-P2 JiZhun Profile up to 1080P@60fps
MPEG-2 MP/HL up to 1080P@60fps (ISO-13818)
MPEG-1 MP/HL up to 1080P@60fps (ISO-11172)
RealVideo 8/9/10 up to 1080P@60fps
RAM 2Gb
Flash eMMC 8GB
Video Output HDMI 2.1 , HDCP2.2
DC Input Range 5V/1.0A
Power Consumption Maximum 5 W
Aspect Ratio Auto, Full screen
Video Resolution 4K,1080p/i, 720p
Video File
Format
Support *.mkv, *.wmv, *.mpg, *.mpeg, *.dat, *.avi,
*.mov, *.iso, *.mp4, *.rm, *.jpg, *.bmp, *.gif etc…
HDMI Dongle
USB
4
DC 5V
4
USB Cable
6
6
Long press Back+Home button at the same time,
until the red light flashes quickly, then release,
that means RCU enter the pairing mode.
Waiting for few seconds and stop pressing any
buttons, until it pop up the message of pairing
successfully.
Model: SN8BABH
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications to this unit not expressly approved by the party
responsible for compliance
could void the user’s authority to operate the equipment.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or
transmitter.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and
operated with minimum distance of 20cm from your body.