G2350 Integrated GPS Car Kit for Treo 650 1
CONTENTS 1. Introduction 2. Diagram and Components 3. Initial Setup 4. Features 5. Mounting Solutions 5.1 Installing the Air Vent Pedestal 5.2 Removing the Air Vent Pedestal 5.3 Using the Air Vent Pedestal + Swivel Adaptor 5.4 Installing the Windshield Pedestal 6.
1. INTRODUCTION Congratulations on your purchase of one of the most advanced, GPS friendly devices ever created – Seidio’s G2350 car cradle for the Treo 650 Smartphone. It has been developed from the ground up for both ease of use and maximum capability. From the custom fit of the cradle to your Treo 650 to the integrated SiRF Star III chipset, no compromises in features or quality have been made.
2.
3. INITIAL SETUP Hardware Step 1: Before you mount the cradle in your car, test to see that your Treo 650 slides easily and snugly into the cradle. Caution: DO NOT force your Treo 650 into the cradle! Step 2: Choose a place and method to mount the cradle. Step 3: Insert the car charger into the 12V socket in your car and connect the other end to the cradle connector labeled “Power In” (See diagram for reference). Caution: DO NOT connect the power cable into the “DC Out”.
4. FEATURES 4.1. 5V DC Out: Additional port for powering your Palm Bluetooth headset. Caution: DO NOT insert the power cable in DC Out. Doing so may cause damage to the cradle or the Treo 650! 4.2. GPS: Built-in SiRF Star III GPS receiver attached via serial connector to your Treo 650. 4.3. Mounting Solutions: Users can mount their cradles based on individual preferences with the included mounting products.
5. MOUNTING SOLUTIONS 5.1 Installing the Air Vent Pedestal 1) Slide the pedestal into your vehicle’s air vent and hook the locking clips onto the back of the vent. 2) To secure the pedestal on the vent, squeeze the locking clips tightly and slide the locks toward the vent. 3) Prop the hinged support arm against a firm base to securely angle the unit up. Now you are ready to slide the cradle onto the pedestal. 5.
4) 5) Select a good spot on your windshield and press the suction cup firmly against it. Press down the latch to secure the suction cup. Slide your cradle on the swivel adaptor. Mounting Installation is now complete. 6. SPECIFICATIONS: Power Input: Input Power Cord: Output Voltage: Output Current: 12V-24V Detachable Car Charger, Hardwire Cable (Optional accessory) 5.2V ± 5% 800mAh (max) For more information and updates, visit our websites at www.seidioonline.com or www.seidio-europe.com.
