Installation Instructions

Pin 1:Ground(GND)

Press and hold to turn the unit on or off.

Press and release to mute or unmute the transmitter.

Option#3

BODY-PACK TRANSMITTER

Mini 4P connector

5.TRANSMITTER(TX)

There are three types of transmitters dedicated to our customer. Customer can select the

transmitters according to their preferences.

Insert two standard AA(1.5V) batteries here, making sure that the positive and negative

polarity marks are oriented correctly, Although NI-CAD rechargeable batteries can be

use, this transmitter cannot recharge them.

Warning: do not insert the battery upside down or it may cause serious damage to your

transmitter and will void the warranty.

This light shows the operation mode:

To turn on or off, keep this button pressed.

To enter “MUTE”mode press and release this button.

This window is used to capture the infrared signal sent from the receiver. During IR

adjustement to pair the transmitter with the receiver, the IR lens must face the receiver

to load the selected channel.

Option#1

HANDHOLD TRANSMITTER

Power/Mute button

Press and hold for 3 seconds to turn the unit on or off, the indicator will light red firstly

and change to light green after about 5 seconds. It enters normal operation mode.

Status indicator

A quick press and release will mute or un-mute the transmitter when the transmitter

turns on. It will light red for mute and green for un-mute.

IR LENS

The window is used to capture the infrared signal sent from receiver. During the IR

SET to channelize the transmitter, the IR lens must face towards the receiver to load

the selected channel.

Battery cover

Insert one standard AA(1.5V) battery here, Being sure the plus and minus polarity

marking of battery are facing correctly. Although rechargeable NI-CAD battery can be

used too, but the unit can’t obtain adequate power to keep working for more than 4

hours. Warning: don’t insert the battery backwards, Or it maybe cause severe damage

to your transmitter and will void your warranty.

Option#2

PEN-SHAPE TRANSMITTER

Protecton Grid

Microphone Body

Battery Cover

Power/Mute Switch

Infrared(IR)

Status lndicator