Installation Instructions

Volume control
Channel 1 Volume Control
Channel 2 Volume Control
Treble Control
Bass Control
Master Control
Battery Status Bar
Recharge Indicator
Power Indicator
Line/Microphone Selector Channel 1
Channel 1 Input Connector
Microphone Receiver
Mixer
Adjusts the level of the microphone signal.
Controls the input signal level of channel 1.
Controls the input signal level of channel 2.
This knob adjusts the gain or attenuation of the channel’s high section at ±10dB.
This knob adjusts the gain or attenuation of the bass section of the channel at ±10dB.
This control adjusts the overall volume of the mixer and affects ALL channels.
This bar of leds indicates the level of the battery charge.
This light turns red when the battery needs to be recharged and green when the
battery is fully charged.
This light will illuminate when the unit has been turned on.
This switch changes the impedance of the Line level channel or Microphone level.
This combo jack has XLR and TRS configuration(Balanced and unbalanced).
Press this key to search for a channel number.
Press this key to adjust parameters inside the receiver.
Press this key to search for a channel number.
Here displayed channel and signal information for radio frequency(RF) and
audio level(AF).
Battery Level
LOWx1
3x4
75%
50%-75%
25%-49%
10%
2x3
1x2
4
Aux input
This 1/8”(3.5mm)connector is the auxiliary channel input connector.
16
Mix Output(Link)
This TRS jack is the mixer output connector that is used to send signal to another
active cabinet or to add a sub-bass.
17
15
F-3 Floor Stand
Display