Network Card User Manual

ManualsBrandsSeiko Group ManualsNetwork CardUB-R02

UB-R02 User’s Manual

Printed in China 2004.01

Introduction

The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio

Frequency (RF) module for EPSON

TM printers.

This manual provides instructions, including a simple setup for operators of

POS systems in which the UB-R02 is installed so that the operators can use the

UB-R02 safely and correctly.

Key to Symbol

The symbol in this manual is identified by its level of importance, as defined

below. Read the following carefully before handling the product.

Note:

Notes have important information and useful tips on the operation of your equipment.

Features and Functions

❏ 64/128-bit WEP

❏ Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for

OPOS)

❏ Transfer rate: up to 11 Mbps, depending on operating environment

❏ OPOS, APD support

Part Names

The following view shows the part names of the UB-R02.

Note: This photograph shows the TM-T88III printer with the UB-R02 installed.

DIP Switches

When using this interface board, the interface of the TM printer must be

selected as “parallel” with the appropriate settings. Set the reset signal for pin

31 to “enable,” if you are using a TM printer that has this setting. Refer to the

manual for each TM printer for details.

Drawer kick-out

connector

Push button

Power supply

connector

410462701

Summary of content (4 pages)

PAGE 1
UB-R02 User’s Manual 410462701 Copyright © Seiko Epson Corporation 2004 Printed in China 2004.01 Introduction The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio Frequency (RF) module for EPSON ® TM printers. This manual provides instructions, including a simple setup for operators of POS systems in which the UB-R02 is installed so that the operators can use the UB-R02 safely and correctly.
PAGE 2
How to Set Up the UB-R02 Preparation Printing a Status Sheet Power on the printer. Wait for a few seconds. Then, hold down the push button on the interface card for more than 3 seconds. The printer prints the parameters for the UB-R02. You can check all setting values necessary (SSID, Network mode, IP address, Subnet mask, Gateway address) for the network connection. Connection Set the setting of the host PC and AP to match the network setting that you have confirmed with the status sheet.
PAGE 3
EMC Standards Applied Product Name: UB-R02 Model Name: M195A The following standards are applied only to the interface boards that are so labeled. (EMC is tested using the EPSON power supplies and TM series printers.) Europe: CE marking North America: EMI:FCC/ICES-003 Class A Oceania: EMC:AS/NZS 3548, CISPR22 Class B WARNING You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment.
PAGE 4
-Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.