User's Manual

- 18 -
(6) Interface cover
This cover is used to connect the interface cable
and the AC adapter, and insert the connector.
Open the rubber cover and insert the connector.
(7) Battery rubber cover
This cover is used to mount and secure the
battery pack. Open the rubber cover and then
attach and detach the battery pack.
(8) Battery release lever
This lever is used to remove the battery pack from
the printer.
(9) Paper cover open lever
This lever is used to open the paper cover in order
to install the paper.
(10) Paper outlet port
This is a paper outlet port equipped with a paper
cutter.
(11) Paper guide unit
This unit is used to install paper. Paper with
various width can be installed.
(12) Paper guide
This guide releases the paper guide lock via lever
(13) according to the paper width and changes
the paper guide width. By attaching and
detaching adapters to it, it is possible to fit several
types of inner diameter.
(13) Paper guide lock lever
This lever is used to release the parper guide lock
when chaging the position of the left and right
paper guides.
(14) Thermal printhead
This printhead prints characters on the paper. Be
careful that It reaches a high temperature just
after printing.
(15) Paper sensor
This sensor detects “no paper” and “timing-mark.”
(16) Paper cutter
This unit cuts paper.
[POWER Lamp Indication]
The POWER lamp comes in three colors - - -green, red, and orange.
Indication POWER lamp
Power OFF Off
Power ON (print ready) Green On
Standby Dark Green On
Charging Orange On
Power voltage failure Red On
No paper, paper cover open Green blinks
Battery voltage low (needs charge) Orange blinks
Error Red blinks