User's Manual
Table Of Contents
- COVER
- COPY RIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1 PREPARATION
- 2 NAMES OF PARTS
- 3 POWER CONNECTING
- 4 PAPER SETUP
- 5 ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6 TEST PRINTING
- 7 FUNCTION SETTINGS
- 8 CONNECTING TO THE HOST COMPUTER
- 9 CHARGING THE BATTERY PACK
- 10 THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11 TROUBLESHOOTING
- 12 SPECIFICATIONS
- 13 OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
- 30 -
QChanging Settings
In the function setting mode, you can initialize or modify settings. To initialize the settings to the default,
follow step (1) shown below. To change the settings, follow step (2) shown below.
(1) Initializing software DIP switch settings
1. When the message shown below is printed in the function setting mode, press the FEED button.
Load Default Setting?
Yes: FEED/No: REPRINT
2. When the message shown below is printed, the printer is turned off. The settings are set to the
default. Initialization is completed.
Default Setting Saved.
Setting Mode Finished.
(2) Changing software DIP switch settings
When the message shown below is printed in the function setting mode, press the REPRINT button.
Load Default Setting?
Yes: FEED/No: REPRINT
Hint
•
When the REPRINT or FEED button is pressed in the function setting mode, the
POWER lamp blinks once. Verify that the POWER lamp blinks.