User Guide

❏ Setup options control codes

This command is specially designed to assist you in utilizing the printer to its fullest

potential. Most of printer's setup options can be accessed and changed through the

following command sequence.

Setup command sequence

Setup declare codes

(1B 7C 60 01 00 11)h

Setup command codes

1B 7C 60 m1 m2

a1...ak

header

m1,m2:Number of data bytes

followed as parameters

(a1..ak). k = (m1 +

(

256 x m2))

Setup terminate codes

(1B 7C 60 01 00 12)h

1. This command sequence is only valid when the Software setup is set to YES

(enabled) in the extended setup options at the front control panel. The

command is treated as regular print data if the software setup is disabled.

2. Always start the software setup commands with the setup declare code and end

by the setup terminate code.

3. In order to store the parameters changed in the setup options through these

control codes, be sure to insert the "Save setup" function code before the setup

terminate codes.

Notes

B. Control code summary (Setup options)