Specifications

23
English
ALARM MODE
[ALARM TIME SETTING]
● The flashing digits move quickly if button C or E is kept pressed.
● When the time function is displayed in the 24-hour indication, the alarm is also displayed in the 24-hour
indication.
● When setting the hour digits in the 12-hour indication, check that AM/PM is properly set.
● If the watch is left untouched in the ALARM SETTING display with the digits flashing, it will
automatically return to the ALARM mode in 2 to 3 minutes.
[ALARM ENGAGEMENT/DISENGAGEMENT]
● When any one of the alarms is engaged, the alarm mark is displayed.
● At the designated time the alarm rings for 20 seconds. To stop it manually, press any of the buttons.
● The alarm can be tested by keeping buttons C and D pressed at the same time in the TIME/CALENDAR
mode.
STOPWATCH MODE
● After 10 hours have been measured, the stopwatch continues measuring from “00”. If it is left
counting for more than 100 hours, it will automatically be stopped.
● The lap number counts up to “199”. After “199”, the number is displayed in two digits such as “00”
for 200, “01” for 201, and so on.
● Even if the STOPWATCH mode is changed to another while the measurement is in progress, it
continues counting properly. After the stopwatch is used, however, be sure to reset it to prevent the
overconsumption of battery energy that would shorten the battery life.
● Even if the digits are reset to “00” in the stopwatch measurement, the stored data is not erased and
can be recalled unless a new measurement is started.
[MEMORY RECALL FUNCTION]
● In the normal display, the lap number is displayed at the bottom row.
● In the enlarged display, the split time is displayed together with the split number.
● If no measurement is made, “NO DATA” will be displayed when button B is pressed to activate the