Instruction manual

Instruction Manual Roundshot D3 - version 4.05 – May 2013 - © by Seitz Phototechnik AG / Switzerland www.roundshot.ch page 43
3.2.5 External device
Press the „External device“ button in the „Parameter“ menu to activate the
„External device“ tab:
This menu controls the connection of the software to any external device including the
camera. The external devices that can be connected to the camera are GPS and compass.
The tab contains the following options:
Camera: open the drop-down list to see all
the cameras present in the network:
• Refresh: click on “Refresh” to refresh the
camera list when connecting a new
camera
• Connect to camera: after selecting the
camera click on “Connect to camera”. The
message “camera ready” should appear in
the message area (bottom right)
• Change IP: change the camera IP address
by clicking on “Change IP”. After
refreshing the camera list it the new IP will
be displayed in the camera list.
If you would like to connect to internet while working
with the camera, then set an IP compatible with your
network (i.e.192.168.178.xx), the same subnet (for
example 255.255.255.0) and the same network
gateway (for example 192.168.178.1). Then change
the camera IP address accordingly (for example
192.168.178.yy)
Open network connections of your computer.
Open LAN connection. choose „internet protocol
TCP/IP“ and „properties“, choose „fixed IP“ and
enter the following IP address: 10.0.0.68
Subnet mask: 255.0.0.0
If the camera cannot be detected, open the network properties and check the settings.
It is important that the network uses a fixed IP in the same range (but not identical) as
the IP of the camera (digital scan back) and that both are located in the same subnet: