Instruction manual

Instruction Manual Roundshot D3 - version 4.05 – May 2013 - © by Seitz Phototechnik AG / Switzerland www.roundshot.ch page 82
4.10 … create turntable scans (continued)
Open „Camera parameters“ tab.
Choose “Turntable” as mode of operation.
This mode is only visible if a Roundshot D3
camera is already connected to the software.
If the turntable mode is not in the list, please
make sure the connection to the Roundshot D3
camera is established.
Once the turntable mode is active, a new
window is displayed on the software. It
contains all specific parameters used for
turntable.
•
Object diameter: enter the diameter of the
object to be scanned.
• Object height: enter the height of the
object to be scanned. This should
correspond to the part of the object that will
be captured by the sensor. It defines the
zoom ratio of the object (60mm for a zoom
ratio equal to 1).
• Position on bench: enter the turntable
bench parameter defining the position of
the 0 mark of the scale.
By default keep this value to 0.
Press to navigate to the “Parameter” menu.
4.10.2 Software adjustments