User's Manual

ENGLISH

-7-

4. Basic Operation

1. Incident or reflected spot measuring

1. To set for either incident or reflected light operation, turn the Incident / Reflected Spot Selector

Switch @8 on the eye piece, to the desired position ( or mark) until it clicks.

2. When incident operation is selected, the

mark will blink for three seconds and when Reflected

Spot operation is selected the

mark will blink for three seconds on the LCD.

NOTE:

• Before taking measurements, always make sure that the desired measurement mode

(

or ) is chosen by checking the LCD or that the Incident/Reflected Spot Selector

Switch is clicked in proper position.

Incident operation Reflected Spot operation