User's Manual

ENGLISH

-5-

3. Before Using

4. Replacing battery during measurement or when using the memory function

1. Always turn the power OFF before replacing batteries. If batteries are removed with the power

ON, measurements and settings in memory can no longer be recalled.

2. If after replacing the battery, or during measurements, strange screens (displays that have not

been set) appear in the LCD, or nothing happens, no matter what button is pushed, remove the

battery and wait at least ten seconds and then replace the battery. This allows the software to

automatically reset, and is not a malfunction.

WARNING:

• Never place batteries in fire, short, disassemble, or heat them. The batteries might break

down, and cause an accident, injury or pollute the environment.

5. Auto Power Off function

1. To conserve battery power, the meter will turn off about twenty minutes after last use.

2. Whether the Auto Power Saving feature turns the power off or the Power button !2 is pressed,

the settings and measured values remain stored in memory. When the Power button is pressed

again the last settings are displayed.

Reference:

・ The power shuts off automatically after 1 minute when the power button is pressed and held.

6. Setting main ISO film speed

1. Hold down the ISO1 button !1 and turn the Set/change

dial t to select ISO film speed for the film being used.

2. You can also change the ISO film speed after taking

measurements. The new value is automatically

displayed.

7. Setting second ISO film speed (ISO 2)

1. This feature is useful when using a second film with

different ISO speed, using Polaroid

proofing film, or

for exposure correction (when using a filter, close-up

photography, etc.).

2. Hold down the ISO 2 button y and turn the Set/change

dial to select ISO film speed of the film being used.

3. Once this is set, after taking a measurement, the mea-

sured value for the second film speed will be displayed

when the ISO 2 button is depressed.

4. You can also change the second ISO film speed after taking

measurements. The new value is automatically is displayed.

Reference:

• The following settings are possible when using custom setting function P33.

1. It is possible to set the amount of correction within a range of ±5 EV in 1/10 steps.

2. When using in movie filming, it is possible to set 7 different frequently used types of filters

(Kodak Wratten filters) (608 Cine compatible).

ISO 1

ISO 2