Operation Manual

5
Measurement
After the measurement, the aperture value will be automatically adjusted to
maintain proper exposure when changes in shutter speed and/or ISO are made.
If ”E.o”(over) or “E.u” (under) appears and blinks, the measurement cannot
be made at the selected settings (See page 23).
•
•
1-2. Setting Frame Rates
Press MODE button to select frame rate
display .
Press UP or DOWN button to set the
desired frame rate.
Press MEASURING button to return to
Shutter Speed Priority mode, and make a
light measurement simultaneously.
Available frame rates include 8, 12, 16, 18, 24, 25, 30, 32, 48, 50, 60, 64, 96,
100, 120 and 128 f/s.
Frame rate sets the lower limit to shutter speed. (i.e. If 30 f/s is set, shutter
speeds are settable from 1/30 sec.)
•
•
1-3. Taking measurements in
Simplified Illuminance mode
Illuminance mode can be selected in Custom
setting (See page 26).
Slide the Lumisphere all the way to the right and
attach the accessory Lumidisc (See page 7).
Press MODE button to select the simplified
illuminance mode.
Position the Lumidisc in front of and parallel
to the area to be measured and press
MEASURING button. Measurements will
be taken continuously and displayed as
illuminance values as long as the button is
pressed. Releasing the MEASURING button
will hold and display the last measurement
value.
1)
2)
3)
1)
2)
3)
13
M
O
D
E
MODE button
UP button
DOWN button
Lumidisc
Lumisphere
Measurement value (Lux)
Measurement value (Foot-Candle)