Operation Manual

5
Measurement
3-2. Measuring Electronic Flash
This measuring method includes the cord and cordless flash modes. When
measurements are taken, the meter will indicate the aperture value required for
proper exposure. The displayed value indicates the total amount of light, including
flash light and ambient light, measured during the shutter speed time set.
3-2-1. Cord Flash mode
This method assures proper synchronization
with flash units. It is necessary for taking
readings of M-Class flash bulbs.
Connect the flash synchro cord to the
synchro terminal on the light meter.
Press MODE button to select cord flash
mode.
Hold ISO button and press UP or DOWN
button to select the ISO sensitivity (See
page 11)
Press the UP button or the DOWN button
to set the desired shutter speed.
Select a shutter speed range that will synchronize with your camera and
flash system.
l
Press the MEASURING button to trigger
the flash. The measurement value (f stop)
will be displayed.
1)
2)
3)
4)
5)
M
O
D
E
MODE button
UP button
DOWN button
ISO button
1/10 step measurement
value (f stop)
Set shutter
speed
Measurement
value (f stop)
19