Operation Manual

5
Measurement
To avoid a danger of choking, please place Synchro terminal cap in a location
where an infant cannot reach and accidentally swallow it. There is a danger of
suffocation.
l
There is a danger of electric shock if the meter is handled with wet hands,
during rain, in areas splashed by water or where there is a lot of moisture.
This may also result in damage to the meter.
l
The electronic flash unit may trigger when you connect the synchro cord or
operate the POWER button.
A cord-connected flash may not fire if the flash unit has an extremely low
trigger voltage. If this happens, use the Auto Reset Cordless Flash mode
(See page 21).
l
l
Use Custom Setting to display shutter speed values in full, 1/2 or 1/3 values
(See page 26).
Shutter speed can be set from 1 sec. through to 1/500 sec. Special shutter
speed settings will appear above 1/500 sec. (1/75, 1/80, 1/90 and 1/100 sec.)
The displayed aperture value will be cancelled if the shutter speed is changed
after a cord measurement is taken. In such cases please measure again.
If the ISO setting is changed after measuring, the displayed aperture value
will be automatically adjusted for the proper exposure.
If “E.o”(over) or “E.u” (under) appears and blinks, the measurement cannot
be made at the selected settings (See page 23).
•
•
•
•
•
20