Operation Manual

5
Measurement
3-2-2. Auto Reset Cordless Flash mode
Use this mode when a Synchro cord is too short, not available or use of a cord is
inconvenient.
Press the MODE button to select to the
Auto reset cordless flash mode.
Hold ISO button and press UP or DOWN
button to select the ISO sensitivity (See
page 11)
Press the UP button or the DOWN button
to set the desired shutter speed.
Select a shutter speed range that will synchronize with your camera and
flash system.
l
When the MEASURING button is pressed,
the mode mark will blink to indicate
that the meter is ready to measure. The
ready to measure mode will continue for
approximately 90 seconds.
Fire the flash to make a measurement.
If the 90 second period is exceeded and the blinking mark stops, press
the MEASURING button again to return to ready to measure status.
•
1)
2)
3)
4)
5)
M
O
D
E
MODE button
UP button
DOWN button
ISO button
Set shutter speed
21
1/10 step measurement
value (f stop)
Set shutter
speed
Measurement
value (f stop)