Operation Manual

5
Measurement
4. Out of Display Range / Measurement Range
4-1. Out of Display Range
4-1-1. When “E.o” (Exposure Over) appears on the display
If the measured value requires a display value above the maximum display range,
“E.o” (Exposure over) will appear even though measured value is within the
meter’s measuring range. In this case, make one of the following adjustments to
display the measured value.
Press UP button to select a faster shutter speed setting.
Set lower ISO by pressing DOWN button while holding ISO button.
If possible, lower the output power of light source, and take another
measurement.
Display: HD_CINE mode
4-1-2. When “E.u” (Exposure under) appears on the display
If the measured value requires a display value below the minimum display range,
“E.u” (Exposure under) will appear even though measured value is within the meter’s
measuring range. In this case, make one of the following adjustments to display
the measured value.
Press DOWN button to select a slower shutter speed setting.
Set higher ISO by pressing UP button while holding ISO button.
If possible, raise the output power of light source, and take another measurement.
Display: HD_CINE mode
4-2. Out of Measurement Range
4-2-1. When “E.o” (Exposure over) blinks on the display
If the brightness exceeds the measuring range of the meter, “E.o” will blink to indicate
that measurements cannot be made. In this case,
if possible, adjust the flash output power or move
away from the light source and take another
measurement.
1)
2)
3)
1)
2)
3)
23
Display: HD_CINE mode