Operation Manual

3
Before Using
5. Replacing battery during operation
Always turn the power OFF before replacing the battery.
If an unexpected display appears on the LCD during battery replacement
or measurement, ie. settings other than selected, or if the meter does not
respond when a button is pressed, remove the battery, wait at least 10
seconds, and then re-install the battery.
6. Auto Power OFF function
To conserve battery power, the meter will turn OFF about four minutes after last
use.
The settings and measured values remain stored in memory when the meter
turns OFF either by Auto Power OFF or by pressing the POWER button. When
the POWER button is pressed again the last settings are displayed.
If the POWER button is pressed and held when the power is off, the meter
will turn ON for about 1 minute, and then turn OFF automatically. (Battery
capacity can be saved if the POWER button is pressed during transport and
storage.)
•
•
1)
2)
5