Operation Manual

36
5-2-3. Cord Multi (Cumulative) Flash Mode
This Measuring mode is used when the light
generated by the ash is inadequate for proper
exposure. Use a synchro cord (sold separately) and
connect the ash to the meter to re the ash. The
repeated ash pops can be accumulated until the
desired aperture is displayed.
The cumulative count is up to 99 times, and
displayed in the Test/Title eld on the LCD screen.
To activate this multi (cumulative) mode, set Cord
Multiple (Cumu.) Flash mode ON in the Custom Setting
(See P55 for details).
1. Connect the synchro cord (sold separately) to
the synchro terminal
13
of the meter.
2. Touch the Measuring mode icon to open
the Measuring Mode Selection Screen, then
touch the
icon to select Cord Multiple
(Cumulative) Flash Mode and return the
screen view to Measuring screen. (See P25
for details.)
3. Set ISO sensitivity value on ISO icon.
4. Set shutter speed on T (shutter speed) icon.
*
Be sure the settings are within the
specications of the ash equipment.
5. Press the Measuring button
8
on the side of
meter.
The ash will re and the measured value (f-stop)
will be displayed.
6. Repeat this operation (pressing the
Measuring button
8
on the side of meter)
only for the number of times necessary.
The accumulated measured value (f-stop)
and the number of cumulative ashes are
displayed.
,
•
e electronic ash unit may trigger when the meter or ash is turned ON or when the synchro cord is plugged into
the meter.
•
Triggering voltage is 2.0 to 300 volts. Below 2.0V, trigger the ash with Cordless Flash Mode. (See P35 for details) or
Radio Triggering Mode (See P41 for details).
•
When measuring a ash bulb, be sure to check the synchronization range and set the proper shutter speed.
Synchro terminal
13
Setting
values
Percentage
of ash
Measuring value (f-stop)
Measuring screen
(Cord multi ash Mode)