Operation Manual

37
5-2-4. Cordless Multiple (Cumulative) Flash Mode
This Measuring mode is used when the light generated by the ash is inadequate
for proper exposure. The repeated ash pops can be accumulated until the desired
aperture is displayed.
The cumulative count is up to 99 times, and displayed in the Test/Title eld on the LCD
screen.
To activate this multi (cumulative) mode, set Cord Multiple (Cumu.) Flash mode ON in the
Custom Setting (See P55 for details).
In this measuring mode, the meter is set to measuring standby status (90 seconds) by
pressing the Measuring button
8
on the side of meter, and during this standby time
re the ash to take measurements. The measured value (f-stop) is displayed for each
trigger of the ash.
1. Touch the Measuring mode icon to open
the Measuring Mode Selection Screen, then
touch the
icon to select Cordless
Multiple (Cumulative) Flash Mode and return
the screen view to Measuring screen. (See
P25 for details.)
2. Set the ISO sensitivity value one the ISO
icon.
3. Set the shutter speed on the T (shutter
speed) icon.
*
Be sure the settings are within the
specications of the ash equipment.
4. Press the Measuring button
8
on the side of
meter.
The meter will be put into measuring standby
mode for 90 seconds and the measuring
mode icon
will blink, and the illumination of
LCD screen dims not to aect to the reading.
5. Trigger the ash unit manually while the
Measuring mode icon
is blinking.
The light will be measured and the measured
value (f-stop) is displayed.
*
If 90 seconds period is exceeded and the
icon stops blinking before the ash has been
triggered, press the Measuring button
8
again to return to ready to measure status.
6. Even after measurement, the
icon
continues blinking and the meter is in ready
to measure status.
7. Repeat this operation (pressing the
Measuring button
8
on the side of meter)
only for the number of times necessary.
The accumulated measured value (f-stop) and
the number of cumulative ashes are displayed.
8. To release (cancel) the measuring standby
status while the icon
is blinking for 90
seconds, touch the screen, or press either
the Memory button
5
or Menu button
7
.
Setting
values
Percentage
of ash
Measuring screen
(Cordless multi ash mode)
Measuring value (f-stop)