Technical data

-30-

The RT-32CTL transmitter is built into the Sekonic L-758DR. The RT-32CTL transmitter

triggering channels. The CE version of meters have 3 ControlTL channels.

All meters offer three selectables zones (A, b, c). Press one of the buttons on meter face

maked A, b or c) to select or deselect a zone. A corresponding indicator will appear on the LCD.

ln order to trigger a flash unit, it must be connected to a PocketWizard ControlTL receiver

< Example in use of FCC & IC version RT-32CTL with compatible ControlTL receivers >

For L-758D/758CINE: Open the battery compartment cover , remove connector cover 25

and install the RT-32CTL Radio Transmitter module (optional) by aligning the connector with the

1. Select the Wireless Flash ControlTL Channel Setting

Mode by turning the Jog wheel while pressing

the Mode button until “Ctl” appears on the upper

3. The set channel number will blink, turn the Jog wheel to select the desired channel.

The channel numbers (1 to 20) will appear in the F-stop display area.

Three ControlTL zones (A, b and c) are displayed in the T (shutter speed)

display area. If a zone is deselected, a “-” will appears in it's place.

5. Measurement

【Wireless Flash ControlTL Channel Setting Mode】

pins and pressing it into place. Replace the battery compartment door.

right side of the LCD.

can be purchased separately and user-installed into the Sekonic L-758D and L-758Cine

meters. When used in the FCC&IC versions of the meters, the transmitter has 20 ControlTL

set to the same channel and zone to be triggered by the meter.