User Manual

15
2. About PocketWizard Wireless Technology
●
NOTICE
Make sure that the settings are within the specications of the camera and ash system.
6.
Make sure that the channel and Zones are
the same for the meter and receivers in use.
(P4, P6)
7.
Press the Measuring Button 6.
The measured value (F-stop) is
displayed. Press the Measuring
Button again to re a ash and
measure until the desired F-stop is
displayed.
The accumulated measured value
(F-stop) and the cumulative count are
displayed.
NOTICE
● In case of the followings, please follow “Cord Flash Mode”.
• When ring the ash, if the ash brightness is lower than the ambient light, the meter
may fail to detect the light.
• Rapid start uorescent lamps and special lighting are sometimes mistaken for ash
and accidentally measured.
• Even if the ash is not red, when a sudden light change occurs in the light receptor,
measurement may be made.
• The waveform of a ash bulb has a slight slope and there is a possibility that the light
meter cannot recognize the ash bulb in Cordless Flash Mode.
● The EV scale cannot be displayed in the Multiple (Cumu.) Flash Mode.
NOTE
For radio CH frequencies, refer to “5. Radio Channel Frequencies”. (

P29)
Measuring Screen
Measuring Screen
Radio CH and Zones
Measured value
(F-stop)
Cumulative count