User Manual

7. Troubleshooting

●

Troubleshooting

If your meter is not operating properly, as you expect, please consult the following

conditions and attempt the suggested solutions before contacting Sekonic. Non-

operation can be due to incorrect, mis-setting of the meter or battery condition.

Should your meter be malfunctioning, please contact place where meter was

purchased or Sekonic for service and repair.

Condition Possible reasons What to do

Flash cannot be

triggered in Radio

Triggering Flash

Mode.

Is the radio receiver in the

ash compatible with the

meter’s transmitter? Isn’t any

other non-compatible brand or

manufacturer used?

Make sure that both the meter

and plug-in external or built-in

PocketWizard receivers to the same

system (Standard and/or ControlTL).

http://www.pocketwizard.com/

Are the meter transmitter and

receivers set for the same

channel number?

Set the same channel number and

zones on the transmitter and the

receivers.

Are the meter and receiver set

for the same ControlTL and/or

Standard channel and zones?

Check that the transmitter and

receiver are both set to the same

system (either the standard system

or ControlTL system).

Are the meter transmitter

and receiver set for the same

frequency?

As there are two types of frequency

(344 MHz band and 433 MHz

band), ensure that the transmitter

and frequency have the same

specications.