Installation Guide
Right and le mechanism are now both evenly adjusted and balanced and that the springs are uniformly engaged.
With the plaorm at 15° from vercal use a 24MM socket and wrench to SEQUENTIALLY ghten both mecha‐
nisms an equal number of turns in mulples of 8 to 10 strokes at a me. (The bed frame will obstruct full turns)
Tighten one side and then the other to maintain equal balance. A 24MM socket and a ratchet wrench are
suggested to avoid damage to the plasc cap on the adjusng handle and to apply proper torque.
Lower the plaorm doorunl the bed is parrelle to the floor. At this pointyou may judge for yourself if the
weight of the bed is to heavy, ghten tension handles further (Always in the vercal posion) to obtain the
perfect seng.
Maress Must be in Place
to adjust Tension
Pardo Counter Balance System Part
1. Counter Balance Equilibrators
2. Pivot mount Plates
3. Support Legs/ Maress Retainer
4. Fastener & Parts bag
Equilibrators are “handed” le and Right.
Note the square axle locaon “A” on this
image is the Le equilibrator and must be
posioned on the le side of the bed frame.
SELBY Furniture Hardware Company
321 Rider Ave.
Bronx, NY 10451
Call ∙ 718 993 3700 ∙ ∙ Fax 718 993 9143 ∙ ∙ Mail To: selbern@aol.com