Owner's Manual

Situate speakers and grilles with logos
how you like and screw speakers in
place with the screws that came with
your speakers. Most of the time the
screws will grab and make their way
through the plastic. You can pre-drill
some holes with a small drill bit if needed.
1
Pop off tweeter covers with
plastic mini pry bar or thin
flathead screwdriver.
2
2
Remove two bolts for each tweeter
with a 7mm socket and ratchet.
3
Replace the poly-fill, spreading it out
inside the pods, making sure the wires
are hanging out. Connect terminals to
speaker. Large terminal is pos.+ and
small terminal is neg.-
Installation type #2: 2015-2018 models with “standard”
systems (Non-Premium Infinity®/Alpine® systems,
meaning no factory subwoofer in the cargo area).
Driver-Side images are shown, simply
repeat process for passenger side.
Disconnect and remove factory tweeters. If one
of those wires (Driver side) has an orange stripe,
you have a “premium” system and must follow
Installation #3 and need the #3 install wire
harness instead. #PP0718-IA or #PP0718-IA-K
(with Kicker speakers) are the versions for your
vehicle.
Find the pods’ sweet spot. You’ll find
the pods kind of lift and slide up the Jeep
pillar slightly to find the correct position.
Hold pod in place with one hand and run
the upper self-tapping screw through the
pod and into the plastic pillar piece until
just snug. Run the lower screw in next.
7
8
9
Push larger speaker terminal
of Pillar-Pod connectors through
grommet first, then the smaller.
(Tight fit to minimize air escaping).
4
Remove poly-fill from pods for the
moment. Run speaker terminals
through small hole in back of each
pod and seat grommet in hole by
pushing it in and picking it through
with your other hand.
.
5
6
Good approx. locations for self-tap
screws shown by white dots inside
pod. May help to pre-drill but not
absolutely necessary. If you do, be
sure to remove any plastic shavings
on the other side from drilling through
so you get a nice fit on the plastic
windshield piece on the Jeep.