SUPERPLUS REPLACEMENT WATER FILTRATION CARTRIDGE For Model #: SP20-1RC INSTRUCTIONS/ASSEMBLY USE AND CARE MANUAL (Important: Read this manual thoroughly before install) Product Customer Support Hotline: Toll Free: 1-800-635-4017
TABLE OF CONTENTS 2 General Notes 3 About Your Product 4 Cartridge Change-Out 5 QR Code Instructions 6 Troubleshooting & Repair HELP AND SUPPORT Selecto, Inc. 3980 Lakefield Court Suwanee, GA 30024 USA 678-475-0799 | 1-800-635-4017 | Customer-Service@SelectoInc.com WWW.SELECTOINC.COM © Selecto, Inc.
THANK YOU FOR PURCHASING OUR PRODUCT Everyone here at Selecto, Inc. would like to thank you for your support and continued use of our products. We believe everyone should have access to safe, clean water. Your purchase is a significant step towards a clean future. GENERAL NOTES It is important to ensure that you are in compliance with all applicable state and local plumbing codes before you start installation of this product.
ABOUT YOUR PRODUCT SP20-1RC Fits the SP20-1 Water Filtration System. Dimensions: 7” × 7” × 23” Outer Box Dimensions: 24” × 6.625” × 6.625” Weight: Without Water: 10 lbs. Packaged Weight: 11 lbs. © Selecto, Inc.
CARTRIDGE CHANGE-OUT INSTRUCTIONS Cartridges should be changed at least once a year, when the pressure on the gauge has dropped into the red zone (less than 20 psi), or when bad tastes and/or odors return. 1. Shut off inlet valve 2. Push “Red” pressure relief button to relieve pressure Normally located at left end of the filter system. Push until no more water comes out. 3.
QR CODE INSTRUCTIONS Record the cartridge change date on the label located on the side of the filter head. It is recommended to replace cartridges at least once a year, or when the pressure on the gauge has dropped into the red zone (less than 20 psi), or when bad tastes and/or odors return. Use the QR code to register and receive an email alert when it’s time to change the filtration cartridges to maximize filter performance. Get email alerts! 1.
TROUBLESHOOTING AND REPAIR All SuperPlus Filtration Systems are fully inspected and pressure tested by factory. IF LEAKS- Note: The inlet shut-off valve must be turned “OFF” (handle in vertical position), and pressure relieved by pushing the “Red” pressure relief button before attempting to fix any leakage problems. 1. Leaks at threaded connection points. This type of leak should be repaired by removing the fitting and applying additional Teflon tape or thread sealant compound.
