Instructions / Assembly

8
© Selecto, Inc.
DIRECTIONS TO REVERSE WATER FLOW
NOTE: Not recommended, unless necessary
EXCHANGE PROCEDURES
See below diagram. Begin by pulling out the blue clips on either side. Proceed to remove the 4 ttings (two from
each end) and exchange with the opposite end. Properly install all ttings back on the lter head. If using hard
copper piping, use the same technique from pages 4 and 5 (ref. Steps 2-7). If using rigid plastic piping, use the same
technique from pages 6 and 7 (ref. Steps 2-7).
Plug
300-715
Plug
300-715
Filtered Outlet
300-720
Filtered Outlet
300-720
Tap Inlet
300-714
Tap Inlet
300-714
(Reversal of water ow path from right to left completed)
(How to reverse the water ow direction)
Pressure Relief
300-738
Pressure Relief
300-738