SUPERPLUS REPLACEMENT WATER FILTRATION CARTRIDGE For Model #: SP20-2RC, SP40-2RC INSTRUCTIONS/ASSEMBLY USE AND CARE MANUAL (Important: Read this manual thoroughly before install)
TABLE OF CONTENTS 2 General Notes 3 About Your Product 4 Cartridge Change-Out Instructions 5 QR Code Instructions 6 Troubleshooting & Repair HELP AND SUPPORT Selecto, Inc. 3980 Lakefield Court Suwanee, GA 30024 USA WWW.SELECTOINC.COM Product Customer Support Hotline: Toll Free: 1-800-635-4017 Customer-Service@SelectoInc.com Monday to Friday 8:00 a.m. — 5:00 p.m. EST © Selecto, Inc.
THANK YOU FOR PURCHASING OUR PRODUCT Everyone here at Selecto, Inc. would like to thank you for your support and continued use of our products. We believe everyone should have access to safe, clean water. Your purchase is a small step towards a clean future. GENERAL NOTES It is important to ensure that you are in compliance with all applicable state and local plumbing codes before you start installation of this product.
ABOUT YOUR PRODUCT SP20-2RC SP40-2RC Fits the SP20-2 Water Filtration System. Fits the SP40-2 Water Filtration System. Dimensions: 7” × 7” × 23” Dimensions: 7” × 7” × 17” Outer Box Dimensions: 24” × 13.5” × 6.625” Outer Box Dimensions: 17.775” × 13.5” × 6.625” Weight: Without Water: 19 lbs. Weight: Without Water: 12.5 lbs. Packaged Weight: 20 lbs. Packaged Weight: 13.5 lbs. © Selecto, Inc.
CARTRIDGE CHANGE-OUT INSTRUCTIONS Cartridges should be changed at least once a year, when the pressure on the gauge has dropped into the red zone (less than 20 psi), or when bad taste and/or odor return. 1. Shut off inlet valve 2. Push “Red” pressure relief button to relieve pressure Normally located at left end of the filter system. Push until no more water comes out. 3.
QR CODE INSTRUCTIONS It is recommended to replace cartridges at least once a year, or when the pressure on the gauge has dropped into the red zone (less than 20 psi), or when bad taste and/or odor return. Use the QR code to register and receive an email alert when it’s time to change the filtration cartridges to maximize filter performance. Get email alerts! 1. Scan the QR code on filter cartridge label with your smart phone. 2.
TROUBLESHOOTING AND REPAIR All SuperPlus Filtration Systems are fully inspected and pressure tested by factory. IF LEAKS- Note: The inlet shut-off valve must be turned “OFF” (handle in vertical position), and pressure relieved by pushing the “Red” pressure relief button before attempting to fix any leakage problems. 1.
