User's Manual

Selex ES S.p.A.
Information contained in this document may not be used, applied or reproduced for any purpose unless agreed
by Selex ES S.p.A. in writing
15
6. Installation
6.1 Overview
The device can be shipped preinstalled in a cabinet or not. If it is not shipped preinstalled in a cabinet,
after unpacking, mechanical installation takes place, followed by electrical connections as described in
this document. The device may be installed in any location suitable for electronic communications
equipment, provided that the environmental conditions do not exceed the equipment specifications for
temperature, humidity, and air quality and that the access to that location is restricted as described
below:
_________________________________________________________________________
- access can only be gained by service persons or by users who have been instructed about
the reasons for the restrictions applied to the location and about any precautions that be
taken; and
- access is through the use of a tool or lock and key, or other means of security, and is
controlled by the authority responsible for the location
_________________________________________________________________________
6.1.1 Installation Pre-requisites
To ensures the best possible performance and reliability of the described equipment pre-installation
planning is required. This includes considering the mounting location of the repeater in relation to input
power and antennas. Also to be considered are site environment conditions, the particular mounting
method and required tools and equipment.
_________________________________________________________________________
To plan the installation, please pay particular attention to environmental condition at the site;
ventilation requirements, grounding and lightning protection as described in this manual.
_________________________________________________________________________