User's Manual

Selex ES S.p.A.
Information contained in this document may not be used, applied or reproduced for any purpose unless agreed
by Selex ES S.p.A. in writing
46
6.4.7 Digital Input/Output Interface
The RBS manages 4 digital outputs. The connector is located on the rear of the RBS and is shown in
red in the following figure.
Interconnecting points
Type of connector terminating
the cable
Type of cable/conductor
User I/O
Socket block B2L 3.5/20LH
Section of each wire ≤
sq.mm. (AWG 18)
I/O Socket block B2L male pinout
type
contact
out
1
power supply alarm (*)
out
2
temperature alarm (*)
out
3
synchronization alarm (*)
out
4
RF power alarm (*)
in
1
not used
in
2
not used
in
3
not used
in
4
not used
in
A1
not used
in
A2
not used
I/O Interface